Step-by-step instructions for gluing inner corners

When completing, the main problem can be uneven walls as well as the resulting springs on the wallpaper. It is also necessary to take into account that if the walls are crooked, the joints of background canvases could invisibly.

After gluing the last one in the front of the inner corner of the cloth must measure the remaining distance. It’s measured from the border of the pasted cloth to the adjacent wall, the resulting figure is added 10-15 millimeters. When the partitions are very curved, then the extra figure could be .

Cut a strip equal to the resulting figure, taking into consideration the allowance. The surfaces are treated with glue. Based on the type of coat it might be just the wall or the surfaces.

The strip is glued independently with the cut side into the wall. The background should go on the other airplane.

In case the glued wallpaper is wrinkled, you need to make a few modest cuts perpendicular to the springs.

Level or incline on the adjoining wall is a vertical line. The distance in the corner is equal to the diameter of the last cut strip, never such as additions.

The surfaces are smeared with glue, and then the coat is glued to the wall with the flat side towards the line. The cut goes onto the adjacent wall.

How to paste the outer corner (outer corner)?

Protruding corner ought to be pasted by analogy using the interior, but there are small differences, which also need to be taken into consideration when working.

Measured the space remaining from the glued wallpaper into the adjoining wall. Add 20-25 millimeters to the captured figure.

A segment is cut away, taking into account the added 20-25 millimeters.

Before gluing, the surfaces have gidpola.ru been treated with glue.

The even edge must be glued into the background already fixed onto the walls, your own cut „extends“ into the adjoining plane. If needed, small cuts are created in the area of visiting another wallpaper, smoothed and pressed into the wall.

Draw a vertical strip onto the adjacent wall at a distance of just glued cut strip plus 6-10 millimeters.

After applying the glue, the strip is then applied to the wall using its flat side towards the marked line, moving over the edge of the already glued strip.

The joints have been smeared with glue and ironed with a rollercoaster. Following that, the top layer is cut across the ruler and the two layers are joined together.